Rotary kiln operation produces the main reason to stop

Article source：

When the rotary kiln large incoming wave, a large number of raw material has been poured into the firing zone, and the burning zone temperature has dropped

significantly, the raw material has more than hot spots, there will be gluten, in order to ensure the quality of clinker should be increased firing temperature, thermal

system as soon as possible to restore stability, must be taken so that emergency measures to stop the firing. Careless operation, defect analysis of the situation, as

well as deal with the issue is not caused by poor treatment following situations prone to stop the kiln firing. Feeding Trinidad and Tobago, raw materials burn

especially poor, failed to add coal, plus wind, slow kiln, raw material Chung had the high temperature zone of the flame, was forced to stop burning. Out a large

number of "kiln skin" but not in time to play a small pre-climbing and to take appropriate measures to enable a large number of raw materials close to the kiln,

firing temperature drops too much, was forced to stop burning. Sometimes the pursuit of fast-forward rate, thick layer soon playing small does not slow, when the

sintering temperature is much lower, the big fight is still slow, raw material crossed the high temperature zone, only forced to stop the kiln, or when the kiln

incoming fluctuations, to steady kiln speed, the stop instead of hitting the slow, using top-fired stoker way, once the stand, I was forced to stop burning. When

feeding coal uniform, less or no less than coal of coal, only pay attention to unequal treatment of coal without timely slow rotary kiln, resulting in the firing

temperature dropped substantially, raw material stormed firing zone, was forced to stop burning . Operation thinking, concentration, sense of duty, not a long time

observing the kiln case, when found raw approximation temperature is low, add coal and idle too late, this time should be forced to stop burning. The above article

by Henan YuFeng Heavy Machinery finishing release, reproduced, please indicate the source!