Autoclaved aerated concrete construction application of technical regulations

Article source：

Autoclaved aerated concrete building Technical specification for application directory:

1 General
2 terminology, symbols,
2.1 Terminology
2.2 Symbols
3 General provisions
4 material calculate the index
5 Structure component.
5.1 The basic calculation of provisions
5.2 Masonry Compressive Carrying Capacity
5.3 Masonry shear capacity calculation
5.4 reinforced by the bearing capacity of the curved plate
5.5 reinforced by the bending stiffness of the plate to calculate
5.6 structural requirements
6 building envelope thermal design
6.1 General provisions
6.2 envelope thermal design
7 building construction
7.1 General provisions
7.2 roof
7.3 block
7.4 The wall panels
7.5 within the wall panels
8 finishes processing
Construction and quality acceptance
9.1 General provisions
9.2 Block Under Construction
9.3 wallboard installation
9.4 Roof Engineering
9.5 wall plaster
9.6 Engineering Quality Acceptance
Appendix A of autoclaved aerated concrete wall sound insulation performance
Appendix 8 of autoclaved aerated concrete fire resistance
Appendix C of autoclaved aerated concrete masonry compressive strength of test methods
Appendix D Masonry level on Shear Strength Test Method
Appendix E Reinforced aerated concrete rectangular section of flexural strength calculation sheet ^
Appendix F of 60 cities envelope winter outdoor design temperature for the name (° C)
This procedure wording of instructions
Attachment: The provision in the

Autoclaved aerated concrete construction applications technical regulations Shuzhai:

2.1.1 autoclaved aerated concrete products to the silicon, calcium, raw materials, aluminum powder (cream) issued gas agent, after the autoclave curing manufactured blocks, plates, and other products.
2.1.2 autoclaved aerated concrete blocks of autoclaved aerated concrete block made, can be used as a load-bearing and non-bearing wall or insulation materials.
Can be divided into the roof, wall panels, wall panels and floor plate made of autoclaved aerated concrete 2.1.3 autoclaved aerated concrete plate. Aerated concrete according to the texture and structure requirements, configure a different number of steel mesh treated with preservatives.
2.1.4 autoclaved aerated concrete mortar and autoclaved aerated concrete performance to match, aerated concrete block to meet the requirements for interior and exterior hand side plate construction and masonry mortar.
Aerated concrete adhesive mortar: cement, graded sand, lightweight aggregate, admixtures, as well as retaining agent, air entraining agent of raw materials in the professional factory mixed by accurate measurement, even for masonry mortar joint thickness greater than 5mm aerated concrete block dry-mixed mortar. The mortar is particularly suitable for the insulation system of a single material of aerated concrete.