Cotton production uses Rotary kiln firing large case

Article source：

For particularly large Rotary kiln production, use or burning firewood injection method not only saves time and effort on the still of

interest, environmental protection also cause some harm.After inspection and practical applications, the use of tampons ignition is not

only practical but also save you a good choice. Firewood for ignition and ignition using tampons differs is that the heat emitted by the

wood burning more adequate, but not the heat emitted by the burning cotton.So what are the specific operation of cotton yarn in the

following aspects we have to make a summary: 1.First, before ignition ready 2-5kg of waste cotton, soaked with oil, put the wire cover

pre-prepared, and good ventilation to maintain loose state, in order to facilitate ignition. 2.A top tube Rotary kiln coal hooked fixed

iron, oil impregnated within the yarn hanging on the wire cover equivalent to approximately two times the diameter of the nozzle from

the coal, the coal nozzle is slightly less than 10-20cm, cotton ball does not make the hair due to the swing, and to ensure ignition of

pulverized coal from the high temperature zone of the flame through. 3.Oil stained with a broom, ignition ignite cotton yarn, cotton yarn

after the fire, who retreated to the Rotary kiln firing, shut the door to work. 4.You can get points with the primary air and pulverized

coal, methods of operation should be three small early in the morning, that a little wind, a small amount of coal, a small ventilation, wind

and coal early delivery time 5.If the 10-15min during coal combustion flame can not be formed, even if the ignition fails to be re-ignition.