Kiln should be done before starting to prepare

Article source：

 

Calcining kiln former staff should begin to examine the entire kiln firing system , make sure all equipment is fully equipped 

with a continuous production conditions. Kiln respectively auxiliary to the main drive commissioning and confirmed after the 

ignition is not due to equipment failure and stop the kiln . Preheater , calciner, conduct a comprehensive inspection within 

the rotary kiln, kiln refractory brick circle check again to endure tight, not loose the emergence of new , exclude debris. 

Recognition system temperature , pressure meter is working properly. The air lift pump and preheater riser system is 

disconnected , so wet flue gas into the gas lift pump , condensate pump bottom layers get wet canvas , the impact of raw 

material transport ; feed efficiency or close all valves hoist export . Kiln coal warehouse should be prepared to sufficient 

quantities of coal, metal magnesium Sand production line      calcination kiln shall comply with the requirements of coal , coal mill should be 

ready to start in the state , in order to ensure a continuous supply of pulverized coal . Open access door cooler drying kiln 

as combustion gas inlet during drying , pulverized coal injection pipes and piping systems to ensure smooth , sealed , 

flexible adjustment . Check the seals around the preheater do a job, find a good point bending kiln shell , and set a good 

initial position of the cement rotary kiln , make a record. Organization personnel to transport firewood kiln stacking 

provisions location , ready diesel , stacking firewood. Ignition process, to wear a good labor protection products , safety 

protection work .