Optional equipment lime kiln bricks selection is very important

Article source：

Lime kiln in the purchase of equipment, it is necessary to use bricks, bricks used must have high quality wear ability, and higher hot strength,

thermal shock resistance also have relatively good, to be able to withstand the temperature and mechanical stress kiln body caused by changing Impact Crusher     

the discharge end portion severe abrasion, and is generally weak in this area. All rotary kilns must adopt the VDZ or ISO standard brick type

brick, because the production of shaped bricks specialized manufacturing technology is very complex, and therefore can not reach the required

cold strength, wear quickly. So when lined with castable kiln built special attention castable material and anchoring and baking, as well as castable

lining in anticipation of the end of the building, brick retaining ring from the kiln discharge end began making castable lining. Around multi-

cylinder rotary kiln cooler parts of the buildings lining the entrance way is completely used castable, and each is shaped bricks or cast steel rings

and castable. In the manufacturing process, this place used castables wear kiln is very strong, with a high refractory anchor, preferably a movable

anchor of a minimum thickness of ten to twelve mm, castable section should not be too and applied to divide the sewing work. Also have

sufficient vent in the area with brick retaining ring leader, can withstand brick lining to the discharge end of the thrust. For refractory anchors,

rotary kiln with multi-tube cooler inlet stereotypes produced bricks and castable mix lining proved to be very appropriate, in order to achieve a

good life, the construction must also have the condition, in the multi-cylinder cooling Machine inlet surrounded by high alumina brick used must

have high strength and wear resistance, only large hydraulic machine pressed standard brick is possible. Serrated turn back, but also to ensure a

combination of brick and castable is good, castable must be properly anchored and also with good abrasion resistance. The above article by

Henan YuFeng Heavy Machinery finishing post!